11. Time
You can set a fade in and fade out time independently for every scene. The fades only affect HTP
(intensity) channels. There is a separate LTP timer which allows you to set movement times. LTP channels
which were set to “instant” during patching ignore LTP fade times.
01) Press <Time/Mode>.
02) Press the playback button of the playback you want to set times for.
03) There are two pages in the menu. Press <Up> or <Down> to browse. Select the desired option and
modify the data by turning the Wheel V.
04) Press <Enter> twice to save and exit or press <Exit> twice to exit without saving.
05) The times you enter are also affected by the scene mode:
Mode 0 – No timing information is used. The HTP channels faded by means of the playback
faders, between 0-100%.
Mode 1 – Channels fade according to the set HTP and LTP fade times (except for Instant LTP
channels). If you enter times for a Mode 0 scene, it will automatically change to Mode 1. If HTP
times are set to zero, the HTP levels will fade with the fader.
Mode 2 – HTP channels fade according to the set HTP times, or with the fader if times are set to
zero. LTP channels are controlled by the fader position (except Instant channels). The initial data
of LTP is the data before the slider is moved up. Set the LTP fade time to 0 to use this mode.
Mode 3 – HTP channels fade according to the set HTP times, or with the fader if times are set to
zero. LTP channels are controlled by the fader position (except for Instant channels). The initial
data of LTP is 0. Set the LTP fade time to 0 to use this mode.
To Next Page
Loading...
