Shure ADX5D - Page 12

Shure Incorporated
12/45
Connectors are (from left to right): 4-pin battery sled power input, TA3 audio outputs 1 and 2, and Hirose 4-pin power
input.
Connecting a Power Supply
Connect a compatible 6-18V power supply to the power input.
CAUTION: Always attach backplate to receiver before connecting power supply.
Battery Sled
Batterysledsmustbeusedwiththestandalonerearpanel,asthispanelincludesthe4pinconnectorrequiredforthetwocom
ponents to mate and pass power. The battery sled is then secured to the receiver using two screws on the rear of the sled,
which ensures that the sled cannot fall off or be removed, and two screws from the front panel to stabilize the sled while on the
receiver.
TheADX5Dcanbepoweredbyasinglebattery;whentwobatteriesareinstalled,onecanbereplacedwithoutinterruptingop
eration. Battery runtime changes depending on the number, type, and capacity of the batteries used.
Insert the battery so that the contact points on the front face connect with the contacts at the rear of the battery sled bay until
the latch moves into place. To remove the battery, push the latch down and pull the battery back and up.