Shure ADX5D - ADX5 D ShowLink Modes

Shure Incorporated
26/45
◦
◦
•
•
•
IR Presets
ConfiguringIRpresetsallowsalltransmitterparameterstobeautomaticallysetfromthereceiverduringanIRsync.Usethear
row buttons to select and edit transmitter parameters from the preset list. Select No Change to keep existing settings.
Advanced
Interference Mgmt
Select interference detection setting for the channel. For more information on each setting, see Interference Detection.
Frequency Diversity
Configure frequency diversity for handheld or bodypack transmitters. Choose between:
Combining: For use with a single ADX2FD handheld transmitter
Selection: For use with a pair of AD1 or ADX1 series transmitters
For more information on these settings, see Frequency Diversity.
FD-S Advanced
View and adjust the advanced FD-S options. For more information, see FD-S Advanced Settings.
Talk Switch
Set receiver output signal routing options for talk switch control from a transmitter. For more information about using a talk
switch with an Axient Digital transmitter, see the talk switch user guide.
Standby
Put this channel on standby to conserve power when you aren't using it.
ShowLink Remote Control
ShowLink remote control uses a wireless network connection to enable real-time remote parameter adjustments for select
portable Axient devices. Whether performers are in the middle of a presentation or off stage waiting for their cue, ShowLink
lets you make crucial changes to transmitter settings without interrupting the performers.
Note: See Country-Specific Functionality Restrictions.
ADX5D ShowLink Modes
To update the ShowLink mode, go to Device Configuration > ShowLink > SL Mode. ADX5D ShowLink modes:
Direct (default)
Network
Off
ShowLink modes: When to use
Mode Reasons for use Needed equipment Example use case
Direct mode
To establish a connection
between a single ADX5D
ADX5D
Crew has a small setup with
a few ADX transmitters and
no need to use Wireless
®
®
®
® ®
®
® ®
®