Shure ADX5D - Transmission Modes; Frequency Diversity

Shure Incorporated
30/45
1.
2.
3.
1.
2.
◦
◦
3.
4.
When the sync is complete, the transmitter will be assigned to the slot. The transmitter will remain assigned to the slot until it is
unlinked. To remove a transmitter from a slot, use the arrow buttons to select the slot. Then, use the arrow buttons to select
Unlink and press O.
Transmission Modes
The receiver offers two transmission modes to efficiently manage the available spectrum used by the transmitters.
Standard Mode
Standard mode employs channel spacing that allows for the operation of transmitters at various power levels.
Standard mode is ideal for situations where spectrum is not limited or when you need to operate transmitters at higher
power levels to increase range.
High Density Mode
High density mode creates additional bandwidth for more channels in crowded RF environments by transmitting at 2 mW
RF power and narrowing the modulation bandwidth.
High density mode is ideal for applications where many channels are needed in a confined area, transmission distances
are short, and the number of available frequencies is limited.
Note: Operation mode varies according to region.
Selecting a Transmission Mode
From the Device Configuration menu, go to Device RF > Trans Mode.
Press O to enable editing. Use the arrow buttons to select a mode.
Press O to save.
Frequency Diversity
Frequency diversity enables seamless, uninterrupted audio for mission-critical applications. Frequency diversity works by
transmittingtheaudioontwoindependentfrequenciesfromanADX2FDhandheldtransmitterorfrom2AD/ADXseriestrans
mitters.
Whenoperatedinfrequencydiversitymode,thereceiverusestwofrequenciestoprovideasinglechannelofaudio.Ifonefre
quency experiences interference, the audio from the other frequency is used to prevent dropouts or interruption of the audio.
Usingfrequencydiversityinconjunctionwithinterferencedetectionprovidesanadditionallayerofprotectionfortheaudiosig
nal.
From the channel menu: Advanced > Frequency Diversity.
Choose one of the following frequency diversity modes:
Combining: For use with a single ADX2FD handheld transmitter
Selection: For use with a pair of AD/ADX series transmitters
Press O to save.
Perform an IR sync between the receiver and the transmitters.