Shure ADX5D - Interference Management; Setting the Detection Mode; Unregistered Transmitter Action; Frequency Server

Shure Incorporated
31/45
1.
2.
◦
◦
•
•
•
1.
2.
3.
FD-S Advanced Settings
Override / Lock
to
Enables the ability to override the FD-S algorithm
and manually select the receiver.
Monitor 3.5mm
Output
Configures the 3.5mm output to monitor pre- or
post- FD-S selection.
Audio Evaluation
When OFF: Only the RF assessment to the FD-S
pairs is made. Recommended when two separate
inputs are in use.
When ON: If both RF channels in the FD-S pair
pass RF assessment, an optional assessment of
the audio signal level is made. If the difference in
the audio level is significant, the algorithm selects
the higher of the two signals.
Interference Management
See Country-Specific Functionality Restrictions.
Intheeventofsignaldegradation,interferencemanagementtechnologyprovidesoptionstomovetoaclean,compatiblefre
quency, either manually or automatically.
Respondtoanalertbymanuallyselectinganewfrequency,orallowtheSpectrumManagerorWirelessWorkbenchtoauto
matically deploy a backup frequency the instant interference is detected.
Tip: To dismiss a interference alert, select the affected channel, and then select Dismiss.
Setting the Detection Mode
The detection mode determines how the receiver will switch to a clear frequency in the event of interference.
Select a channel and navigate to: Advanced > Interf. Mgt > Detection Mode
Choose one of the following modes:
Manual: Select a frequency manually when interference occurs
Automatic: Allow the receiver to automatically select a new frequency
Unregistered Transmitter Action
The unregistered transmitter setting determines how the receiver reacts to the presence of unregistered transmitters, which
canbeapotentialsourceofinterference.Ifatransmitterisnotlistedinthereceiver'sTxSlots,thenthattransmitterisconsid
ered unregistered to the receiver channel.
From the Interf. Mgt menu, choose one of the following options:
Allow: The receiver will pass audio from the unregistered transmitter
Warn: The receiver will display a warning when an unregistered transmitter is detected
Block: The receiver will treat the unregistered transmitter as interference and will block the audio
Frequency Server
The frequency server option allows you to assign a networked Spectrum Manager as a server for clear frequencies in the event
of interference.
From the Interf. Mgt menu, select Freq. Server
Press O to enable editing and select a Spectrum Manager from your network.
Press O to save.