Shure Incorporated
14/87
③ ANI4OUT (digital-to-analog conversion)
From the network switch: Use network cables to connect each ANI4OUT to the network switch. A single
ANI4OUT receives 4 channels of Dante audio, and converts them to 4 analog signals, delivered through XLR out
puts or block connectors. Using two of them, all 8 channels from the array microphone can be connected to analog
inputs on an audio processing device.
To a processing device: Route the ANI4OUT outputs to the processing device inputs to provide digital signal pro
cessing (acoustic echo cancellation).
④ Connection to far end
Connect the output from the audio processor to a VOIP server or telephone line to deliver audio between the near
end and far end.
⑤ Audio from far end to amplifier
Route the far end audio through the audio processor output to an amplifier.
⑥ Amplified audio signal to loudspeakers
Connect the loudspeakers to the amplifier to deliver the audio from the far end
To Next Page
Loading...
