Shure MXA910 - Page 79

Shure Incorporated
79/87
Get PEQ Filter Enable (firmware > v2.0)
Command String:
< GET xx PEQ yy >
Where xx is the PEQ block 01-04.
Where yy is the PEQ filter 01-04
within the block. 00 can be used for
all blocks or all filters.
MXA910 Response:
< REP xx PEQ yy ON >
< REP xx PEQ yy OFF >
Set PEQ Filter Enable (firmware > v2.0)
Command String:
< SET xx PEQ yy ON >
< SET xx PEQ yy OFF >
Send one of these commands to the
MXA910.
MXA910 Response:
< REP xx PEQ yy ON >
< REP xx PEQ yy OFF >
Where xx is the PEQ block 01-04.
Where yy is the PEQ filter 01-04
within the block. 00 can be used for
all blocks or all filters.
Get Automix Channel Solo Enable
Command String:
< GET x CHAN_AUTOMIX_SOLO_EN >
where x is channel number: 0 is not
valid MXA910: channels 1-8
MXA910 Response:
< REP x CHAN_AUTOMIX_SOLO_EN ENABLE >
< REP x CHAN_AUTOMIX_SOLO_EN DISABLE >
where x is channel number: 0 is not
valid MXA910: channels 1-8; where
sts indicates channel x's SOLO
state: ENABLE DISABLE
Set Automix Channel Solo Enable
Command String:
< SET x CHAN_AUTOMIX_SOLO_EN ENABLE >
< SET x CHAN_AUTOMIX_SOLO_EN DISABLE >
where x is channel number: 0 is not
valid MXA910: channels 1-8; where
sts determines the requested state
of SOLO mode: ENABLE DISABLE
MXA910 Response:
< REP x CHAN_AUTOMIX_SOLO_EN ENABLE >
< REP x CHAN_AUTOMIX_SOLO_EN DISABLE >
where x is channel number: 0 is not
valid MXA910: channels 1-8; where
sts indicates channel x's SOLO
state: ENABLE DISABLE