- 56 -
BootUp Num-Lock
This item determines if the Num Lock key is active or inactive at system
start-up time.
Ø The choice: Off or On .
Floppy Drive Swap
If you have two diskette drives installed and you enable this item, drive A
becomes drive B and drive B becomes drive A.
Ø The choice: Enabled or Disabled .
Floppy Drive Seek
If you enable this item, your system will check all floppy disk drives at
start up. Disable this item unless you are using an old 360KB drive.
Ø The choice: Enabled or Disabled .
Password Check
If you have entered a password for the system, use this item to determine,
if the password is required to enter the Setup Utility (Setup) or required
both at start-up and to enter the Setup Utility (Always).
Ø The choice: Setup or Always.
Boot to OS/2
Enable this item if you are booting the OS/2 operating system and you
have more than 64MB of system memory installed.
Ø The choice: YES or No.
L2 Cache
Leave these items enabled since all the processors that can be installed
on this board have internal L1/L2 cache memory.
Ø The choice: Enabled or Disabled .
System BIOS Cacheable
If you enable this item, a segment of the system BIOS will be copied to
main memory for faster execution.
Ø The choice: Enabled or Disabled .
SDRAM Timing By SPD
This item allows you to enable or disable the SDRAM timing defined by
the Serial Presence Detect electrical.
Ø The choice: Enabled or Disabled .
To Next Page
Loading...
