Once the selection made (e.g. %), the unit will also be displayed as piece of information on the display.
Fig. 53
4.5.2.4 Decimal digits
To conclude, it is possible to determine the number of decimal digits from 2-6. The standard setting is 2.
4.5.2.5 Global Memories
If a titration result should be used again later, e.g. the factor or titer of a solution or a blank value, it can be saved
automatically. The creation of a global memory is possible when using an external keyboard only. The creation of
a global memory can be managed with the system settings or by typing Shift + F5 on the external keyboard. This
leads to the <Global memory>:
Fig. 54
A global memory can be added by pressing F3:
Fig. 55
To Next Page
Loading...
