•
Using the SOPAS ET configuration software, on the Illumination Control device page
•
During GSD parameterization with the “10_Object Trigger Ctrl” module (PROFINET
or PROFIBUS)
At the default setting, laser timeout is deactivated.
The laser diode is permanently or repeatedly switched on in the following device sta‐
tuses:
■
In the operating modes “Percentage evaluation” and “Auto setup”. Use these
operating modes only temporarily for configuration or diagnostics.
■
In reading operation in the PSDI types “Auto pulse” (adjustable duty cycle) or
“Free”
If timeout is activated, it will have no effect here.
SAFETY INFORMATION 2
8021479/19ZB/2021-10-29 | SICK T E C H N I C A L I N F O R M A T I O N | CLV62x, CLV63x and CLV64x with IP69K Protective Housing
11
Subject to change without notice
To Next Page
Loading...
Need help?
General
