b Mount t
he sender and receiver at the same height ("). For minor adjustments
when aligning, the sender and receiver can be adjusted longitudinally in the brack‐
ets.
b
If pos
sible, mount the top bracket at a height such that the offset in the multiple
light beam safety device housing rests on the bracket. This ensures that the multi‐
ple light beam safety device will not slip down during mounting (§).
b
Tightening torque for the screws used to mount the bracket: 5 Nm … 6 Nm. Tight‐
ening torque for the screws used to secure the multiple light beam safety device in
the bracket: 2.5 Nm … 3 Nm ($). Higher torques can damage the bracket, while
MOUNTING 5
8020453/14Q7/2020-04-27 | SICK O P E R A T I N G I N S T R U C T I O N S | deTem4 Core
29
Subject to change without notice
To Next Page
Loading...
