About this Manual
6 MCS100E HW Maintenance Manual 8009624/2009-09 (V1.4) ©SICKMAIHAKGmbH
1.1
Target group
The tasks and measures described in this Manual must only be carried out by skilled users
who have been trained and are appropriately qualified to perform the respective tasks on
the MCS100E HW.
1.2 Special hazards
1.3 Purpose of this Manual
This Manual provides instructions concerning the preventive maintenance of the MCS100E
HW.
The technical layout of the MCS100E HW in question can differ from the layout described
in this Manual due to changes made by the manufacturer or customer.
Intervention in the MCS100E HW by persons who have not been trained voids
the
SICK MAIHAK GmbH
guarantee.
WARNING: Damage as a result of improper working
Improper working can damage health and equipment and affect the accuracy
of measurements.
WARNING: Toxic and caustic substances in parts in contact with sample
gas.
Depending on sample gas composition, MCS100E HW parts in contact with
the sample gas as well as the upstream gas path can contain toxic and caustic
substances.
b
Before performing any work on the gas path obtain information concerning
the gases that have been fed to the MCS100E HW.
b
Obtain information as to whether, and then how, the MCS100E HW gas
path has been cleaned.
b
If necessary, clean the gas path with a suitable method.
b
In case of doubt, take appropriate protective measures before working on
the gas path: Ensure adequate ventilation at the workplace or work under a
vent. Wear protective goggles or a safety mask, protective gloves and acid-
proof protective clothes.
If you have questions, if there is something you do not understand or if some-
thing is missing:
b
Contact your local SICK subsidiary or agency.
To Next Page
Loading...
