Need help?Do you have a question about the SICK MSLZ Series and is the answer not in the manual?
General| Switching mode | Light/dark switching |
|---|---|
| Enclosure rating | IP67 |
| Supply voltage | 10 V DC ... 30 V DC |
| Output type | PNP |
| Connection type | Cable |
| Ambient operating temperature | -25 °C ... +55 °C |
| Housing material | Plastic |
Defines the applicability of these operating instructions to the MSL safety switch.
Describes intended applications for guarding hazardous areas on machinery or plant.
Specifies that the MSL safety switch must be used as described in section 2.1.
Outlines regulations and precautions for installation, commissioning, and use.
Explains test purpose for safety confirmation and identifying ambient effects.
Details mounting sender/receiver units using brackets and sliding nuts.
Explains minimum distance from reflective surfaces to the optical axis.
Describes how beam coding prevents mutual influence and ambient light effects.
Covers electrical connection procedures for sender and receiver units.
Shows connection diagrams and test input procedures for sender/receiver.
Illustrates connection possibilities for sender range options.
Explains changing coding and selecting operating modes using DIP switches.
Describes switching on the device and the meaning of LEDs.
Details aligning sender/receiver units for optimal beam detection.
To Next Page
