à
Device number (GN)
á
Maximum 32 users
â
Example of alternative connection module:
Alternative connection module for RFU62x: CDM420-0001 or CDM420-0006.
CDB650-204 only for RFU62x-101xx (Ethernet variant).
CDM420-0001 or CDM420-0006: An adapter cable (female connector, M12, 17-pin, A-
coded / male connector, D-Sub-HD, 15-pin) is required to connect the RFU62x-101xx (Eth‐
ernet variant)
CDB650-204: A connection cable 1:1 (female connector, M12, 17-pin, A-coded/male
connector, M12, 17-pin, A-coded) is required to connect the RFU62x-101xx (Ethernet vari‐
ant)
NOTE
Activate the CAN data interface in the device with a configuration tool, e.g. the configu‐
ration software SOPAS ET.
Make further settings in the device corresponding to the function of the device in the
system configuration.
14.5.7 Wiring digital switching inputs “Sensor 1” and “Sensor 2” of the device in the CDB620-001
Device = RFU62x-104xx (serial variant), RFU62x-101xx (Ethernet variant)
Device
5CDB620-001
V
S
V
S
V
S
GND
GND
SensGND
3.32 K
6.64 K
Sensor E
V
in
D
9
2
1
C
15
1
5
12
SGND
6
Shield
11
U
IN
*
A
Sens B
Out
U
IN
*
GND
S3
ON
OFF
S3 : SGND-GND
Shield
GND
.
.
.
SensGND
Cable 2
Cable 3
Trigger sensor 1
PNP sensor 9
E.g. photo-electric
switch 8
ß
3
1
7
2
6
5
4
8
13
14
17
15
9
10
12
16
11
7 6
110
15
6
11
5
4
Figure 49: Trigger sensor supplied with power by connection module CDB620-001
1
Trigger sensor, e.g. for read cycle generation
2
RFU62x-104xx (serial variant): connecting cable permanently connected with the device (male connector, D-Sub-HD,
15-pin)
3
RFU62x-101xx (Ethernet variant): adapter cable (male connector, D-Sub-HD, 15-pin / female connector, M12, 17-pin, A-
coded)
4
Input voltage V
in
5
Device
6
RFU62x-101xx (Ethernet variant): male connector, M12, 17-pin, A-coded
7
Connection module: female connector, D-Sub-HD, 15-pin
8
e.g. photoelectric sensor
14 ANNEX
100
O P E R A T I N G I N S T R U C T I O N S | RFU62x 8015930/ZTM0/2018-11-06 | SICK
Subject to change without notice
To Next Page
Loading...
