SICK RFU62 Series

7 Commissioning
7.1 Overview of the Commissioning Steps
The device is configured using a configuration tool. During initial commissioning, this is
normally done use the SOPAS ET configuration software.
Other configuration tools are also available, for example a web server or command
strings, depending on the task. For more information, see "Operating options and con‐
figuration tools", page 79.
Procedure
– Install the SOPAS ET configuration software and the required device description
file on a PC or laptop.
– Electrically connect the device to the PC or laptop.
– Commission the device with the help of the “Quickstart” function in SOPAS ET
using the default factory settings and the similarly named Quick Start Guide, a
printed copy of which is enclosed with the device.
– Perform a manual fine adjustment and configuration of the device to optimize the
functionality for the specific reading and writing situation on site.
– Test the device for correct functioning in real reading and writing operation.
7.2 SOPAS ET configuration software
The SOPAS ET configuration software is the standard tool used to configure the device
for the specific reading and writing situation on site. The optimal configuration data for
the device are permanently saved to the device by the user. The data can also be stored
on the PC as a parameter set (project file) for archiving purposes.
The device can also permanently access the parameter set from an optional external
storage medium. This makes it easier to replace the device if necessary. microSD mem‐
ory cards, or the CMC600 parameter cloning module in the CDB or CDM connection
module are available for this purpose. For more information, see "Initial commission‐
ing", page 73.
7.2.1 Device-related functions of the SOPAS-ET configuration software (overview)
NOTE
The general functions of the software and its user interface are described in the
SOPAS ET manual in the SOPAS ET configuration software.
•
Selecting the menu language
•
Setting up communication with the device
•
Password-protected configuration for different operating levels
•
...
The SOPAS ET configuration software provides the following functions, amongst others,
relating to the device:
•
Quickstart function with continuous read cycle triggering to demonstrate the
transponder recognition and data display
•
Access to the transponder content (reading and writing)
•
Management of device apps (log levels)
•
Assistant for targeted configuration of the transponder read operation (Single Tag
ID Wizard)
•
Recording of device and communication data during operation via the diagnostics
log file output
•
System diagnostics
COMMISSIONING 7
8014335/ZTL9/2018-10-14 | SICK O P E R A T I N G I N S T R U C T I O N S | RFU63x, RFU65x
71
Subject to change without notice