Device variant Supply voltage V
S
Ambient operating
temperature
Power source: required power output
No load on either
switching output
Load on both switching
outputs (maximal
100 mA each)
RFU62x-105xx DC 48 V / 57 V according
to PoE technology
–25 °C ... +50 °C At least 10 W, no switching outputs included
•
In the case of connection via the optional connection module CDB/CDM: addition‐
ally required output power 0.5 W when using the optional parameter cloning mod‐
ule CMC600 in the connection module.
Protecting the supply cables
To ensure protection against short-circuits and overload in the customer-supplied
cables, the wire cross-sections used must be selected and protected in accordance
with national regulations.
The following standards must be observed in Germany:
•
DIN VDE 0100 (part 430)
•
DIN VDE 0298 (part 4) and/or DIN VDE 0891 (part 1)
Wiring without SICK connection module
For a supply voltage between 10 V and 30 V DC, protect the device with a separate
0.8 A slow-blow fuse.
b
Install the fuse in the supply circuit at the start of the supply cable.
Wiring with SICK connection module
Deliver the supply voltage via a connection module:
Connection module Interface Reference
CDB620-001 Supply voltage see "Connecting supply voltage
for the device in CDB620-001",
page 95
CDB650-204 Supply voltage see "Connecting supply voltage
for the device in CDB650-204",
page 108
CDM420-0001 Supply voltage see "Connecting supply voltage
for the device in
CDM420-0001", page 121
CDM420-0006 Supply voltage see "Connecting supply voltage
for the device in
CDM420-0006", page 134
6.8 Wiring data interfaces
Wiring the Internet interface
1. Connect the device to the Ethernet interface of the PC via an adapter cable.
2. Set up communication via SOPAS ET configuration software.
NOTE
The Ethernet interface of the device has an Auto-MDIX function. This automatically
adjusts the transmission speed as well as any necessary crossover connections.
6 ELECTRICAL INSTALLATION
58
O P E R A T I N G I N S T R U C T I O N S | RFU62x 8015930/ZTM0/2018-11-06 | SICK
Subject to change without notice