SICK RFU62 Series - Page 121

14.7.2 Connecting supply voltage for the device in CDM420-0001
Device = RFU62x-104xx (serial variant), RFU62x-101xx (Ethernet variant)
Device 4CDM420-0001
V
S
2
1
1
5
5
Shield
1 +24 V
2 GND
+24 V*
GND
S1
F
Shield
GND
.
.
.
.
.
.
.
.
.
ON
OFF
S1 : POWER
+24 V*
POWER
V
S
GND
3
1
7
2
6
5
4
8
13
14
17
15
9
10
12
16
11
V
S
- +24 V -
F
S 1
- +24 V*
6 5
V
s
1
110
15
6
11
5
Cable 2
Cable 3
Figure 68: Connecting supply voltage for the device in CDM420-0001 connection module
1
Supply voltage V
S
2
RFU62x-104xx (serial variant): connecting cable permanently connected with the device
(male connector, D-Sub-HD, 15-pin)
3
RFU62x-101xx (Ethernet variant): adapter cable (male connector, D-Sub-HD, 15-pin /
female connector, M12, 17-pin, A-coded)
4
Device
5
RFU62x-101xx (Ethernet variant): male connector, M12, 17-pin, A-coded
6
Connection module: female connector, D-Sub-HD, 15-pin
Function of switch S1
Table 61: Switch S1: Power
Switch setting Function
ON Supply voltage +24 V connected to CDM420-0001 and device via fuse
and switch S1 as +24 V*.
Voltage +24 V* can be additionally tapped at terminals 29 and 39.
OFF CDM420-0001 and device disconnected from supply voltage.
Recommended setting for all connection work.
14.7.3 Wiring serial host interface RS-232 of the device in CDM420-0001
Device = RFU62x-104xx (serial variant), RFU62x-101xx (Ethernet variant)
ANNEX 14
8015930/ZTM0/2018-11-06 | SICK O P E R A T I N G I N S T R U C T I O N S | RFU62x
121
Subject to change without notice