SICK RFU62 Series

á
Maximum 32 users
â
Example of alternative connection module:
Alternative connection module for RFU62x: CDB620 or CDM420-0006. CDB650-204 only
for RFU62x-101xx (Ethernet variant)
CDB620 or CDM420-0006: An adapter cable (female connector, M12, 17-pin, A-
coded / male connector, D-Sub-HD, 15-pin) is required to connect the RFU62x-101xx (Eth‐
ernet variant)
CDB650-204: A connection cable 1:1 (female connector, M12, 17-pin, A-coded/male
connector, M12, 17-pin, A-coded) is required to connect the RFU62x-101xx (Ethernet vari‐
ant)
NOTE
Activate the CAN data interface in the device with a configuration tool, e.g. the configu‐
ration software SOPAS ET.
Make further settings in the device corresponding to the function of the device in the
system configuration.
14.7.7 Wiring digital switching inputs “Sensor 1” and “Sensor 2” of the device in the CDM420-0001
Device = RFU62x-104xx (serial variant), RFU62x-101xx (Ethernet variant)
Device 5
CDM420-0001
PNP sensor 9
V
S
V
S
V
S
GND
SensGND
3.32 K
6.64 K
Sensor E
V
in
D
9
2
1
C
15
1
5
Out
+24V*
GND
S6
ON
OFF
S6 : SGND-GND
Shield
GND
.
.
.
A
Sensor B
37
SGND
6
Shield
39
+24 V*
GND
SensGND
3
1
7
2
6
5
4
8
13
14
17
15
9
10
12
16
11
Trigger sensor 1
ß
E.g. photo-electric
switch 8
4
7 6
110
15
6
11
5
Cable 2
Cable 3
Figure 73: Trigger sensor supplied with power by connection module CDM420-0001
1
Trigger sensor, e.g. for read cycle generation
2
RFU62x-104xx (serial variant): connecting cable permanently connected with the device (male connector, D-Sub-HD,
15-pin)
3
RFU62x-101xx (Ethernet variant): adapter cable (male connector, D-Sub-HD, 15-pin / female connector, M12, 17-pin, A-
coded)
4
Input voltage V
in
5
Device
6
RFU62x-101xx (Ethernet variant): male connector, M12, 17-pin, A-coded
7
Connection module: female connector, D-Sub-HD, 15-pin
8
e.g. photoelectric sensor
9
PNP sensor
ß
Supply voltage V
S
14 ANNEX
126
O P E R A T I N G I N S T R U C T I O N S | RFU62x 8015930/ZTM0/2018-11-06 | SICK
Subject to change without notice