SICK RFU62 Series - Page 270

A connection cable 1:1 (female connector, M12, 17-pin, A-coded/male connector, M12,
17-pin, A-coded) is required to connect the device
NOTE
Activate the CAN data interface in the device with a configuration tool, e.g. the configu‐
ration software SOPAS ET.
Make further settings in the device corresponding to the function of the device in the
system configuration.
14.6.7 Wiring digital switching inputs “Sensor 1” and “Sensor 2” of the device in the CDM420-0006
Device = RFU63x-131xx, RFU63x-041xx
Device = RFU65x-101xx
Device 4
CDM420-0006
PNP sensor 8
V
S
V
S
V
S
GND
SensGND
3.32 K
6.64 K
Sensor E
V
in
D
9
2
1
C
15
1
5
Out
+24V*
GND
S6
ON
OFF
S6 : SGND-GND
Shield
GND
.
.
.
A
Sensor B
37
SGND
6
Shield
39
+24 V*
GND
SensGND
3
1
7
2
6
5
4
8
13
14
17
15
9
10
12
16
11
Trigger sensor 1
9
E.g. photo-electric
switch 7
3
6 5
110
15
6
11
5
Cable 2
Figure 63: Trigger sensor supplied with power by connection module CDM420-0006
1
Trigger sensor, e.g. for read cycle generation
2
Adapter cable (male connector, D-Sub-HD, 15-pin / female connector, M12, 17-pin, A-coded)
3
Input voltage V
in
4
Device
5
Device: male connector, M12, 17-pin, A-coded
6
Connection module: female connector, M12, 17-pin, A-coded
7
e.g. photoelectric sensor
8
PNP sensor
9
Supply voltage V
S
14 ANNEX
122
O P E R A T I N G I N S T R U C T I O N S | RFU63x, RFU65x 8014335/ZTL9/2018-10-14 | SICK
Subject to change without notice