Instructions to action
►
The arrow denotes instructions to action.
1. The sequence of instructions is numbered.
2. Follow the order in which the numbered instructions are given.
✓
The tick denotes the results of an action.
2 Safety information
2.1 General safety notes
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
This product does not constitute a safety component as defined in the
Machinery Directive.
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
2.2 Intended use
The WLG4S is an opto-electronic photoelectric retro-reflective sensor (referred to as
“sensor” or “product” in the following) for the optical, non-contact detection of objects,
animals, and persons. A reflector is required for it to function. If the product is used
for any other purpose or modified in any way, any warranty claim against SICK AG shall
become void.
WLG4S is a photoelectric retro-reflective sensor with optional add-on for detecting
transparent objects.
2.3
Qualification of personnel
Any work on the product may only be carried out by personnel qualified and authorized
to do so.
Qualified personnel are able to perform tasks assigned to them and can independently
recognize and avoid any potential hazards. This requires, for example:
•
technical training
•
experience
•
knowledge of the applicable regulations and standards
3 Product description
3.1 Product identification via the SICK product ID
SICK product ID
The SICK product ID uniquely identifies the product. It also serves as the address of the
web page with information on the product.
The SICK product ID comprises the host name pid.sick.com, the part number (P/N),
and the serial number (S/N), each separated by a forward slash.
OPERATING INSTRUCTIONS
80282151N09/2024-03-12 | SICK O P E R A T I N G I N S T R U C T I O N S | WLG4S
31
Subject to change without notice
en
To Next Page
Loading...
