Safety regulations for the method of operation
2
A6V10430571_en--_c 11 | 57
Depiction of risk of injury
Notes on risk of injury is depicted as follows:
WARNING
Consequences in the event the hazard occurs
Measures/prohibitions to prevent the hazard
DEPICTION for possible damage to property
Notes on possible damage to property is depicted as follows:
NOTICE
Type and source of hazard
Consequences in the event the hazard occurs
Measures/prohibitions to prevent the hazard
2.2 Safety regulations for the method of operation
National standards, regulations and legislation
Siemens products are developed and produced in compliance with the relevant
European and international safety standards. Should additional national or local
safety standards or legislation concerning the planning, mounting, installation,
operation or disposal of the product apply at the place of operation, then these
must also be taken into account together with the safety regulations in the
product documentation.
Electrical installations
WARNING
Electric shock
● Work on electrical installations may only be carried out by qualified
electricians or by instructed persons working under the guidance and
supervision of a qualified electrician, in accordance with the
electrotechnical regulations.
● Wherever possible disconnect products from the power supply when
carrying out commissioning, maintenance or repair work on them.
● Lock volt-free areas to prevent them being switched back on again by
mistake.
● Label the connection terminals with external voltage using a
'DANGER External voltage' sign.
● Route mains connections to products separately and fuse them with their
own, clearly marked fuse.
● Fit an easily accessible disconnecting device in accordance with
IEC 60950-1 outside the installation.
● Produce earthing as stated in local safety regulations.
To Next Page
Loading...
Need help?
General
