4.2.3 Extended configuration
To change the device configuration online in ABT Go:
1.
Go to
Device
>
Configuration
>
Online configuration extended
NOTICE
: Entering the Configuration mode stops the application!
Cancel
aborts without changes.
2.
Tap
OK
.
a The device is set to the Configuration mode.
NOTE:
If you want to leave this mode without having any changes applied,
you have to manually set the setpoints back.
3.
Select your choices and modify the values according the requirements of the
customer plant.
4.
Tap
Apply - Restart application.
a The device restarts and processes the new configuration.
a After a successful restart the device state is set to Operational.
a The settings of the choices are applied, data points and parameters are set
accordingly.
Configuration
ABT Go configuration
4
28 | 170 A6V10733786_en_c
To Next Page
Loading...
