Siemens Climatix S300 HRV - 4.3 Choosing the functions

4.3 Choosing the functions
Refer to the list below to set the functions of the application accordingly. Some of
the functions may require certain hardware (peripheral devices).
Control functions
Control function BACnet object Selection Note
Ventilation control STR_VIEW, 402 Ventilation control 21y, air
volume flow
Controls the measured air flow to values depending on
the operating mode and air quality
Ventilation control 22y, air duct
pressure
Controls supply and extract air duct pressure to values
depending on the operating mode and air quality
Ventilation control 23y, fan
speed
Controls supply and extract fan speed to values
depending on the operating mode and air quality (default)
Temperature
control
STR_VIEW, 103 Supply air temperature control
21y
Controls supply air temperature to a value depending on
the outside air temperature modulating the available
actuators (default)
Temperature cascade control
21y
Controls room or extract air temperature to a value
depending on the outside air temperature modulating the
supply air temperature setpoint
Kitchen hood
ventilation
operation
STR_VIEW, 168 None No kitchen extract fan available (default)
Active Kitchen extract fan available (default)
Fireplace
ventilation
operation
STR_VIEW, 112 None No open fireplace available
Active Open fireplace available (default)
Dehumidification
control
STR_VIEW, 115 None No humidity control available (default)
Active Dehumidification control via fan speed and / or stand-
alone dehumidifier
Particulate matter
control
STR_VIEW, 324 None No particulate matter control available (default)
Active Particulate matter control available
Air quality control STR_VIEW, 352 None No air quality control available (default)
Active Air quality control available
Configuration
Choosing the functions
4
A6V10733786_en_c 29 | 170