CP 343-1
Manual, 12/2018, C79000−G8976−C201-08
67
Note
Issued approvals on the type plate of the device
The specified approvals apply only when the corresponding mark is printed on the product.
You can check which of the following approvals have been granted for your product by the
markings on the type p
late.
Approvals for shipbuilding are not printed on the device type plate.
Current approvals on the Internet
You will find the current approvals for the product on the Internet pages of Siemens Industry
Online Support.
Link: (http://support.automation.siemens.com/WW/view/en/10806075)
EC declaration of conformity
The product meets the requirements and safety objectives of the following EC directives and
it complies with the harmonized European standards (EN) for programmable logic controllers
which are published in the official documentation of the European Union:
● EC Directive 2004/108/EEC "Electromagnetic Compatibility" (EMC Directive)
– Immunity - EN 61000-6-2 : 2005
– Emission - EN 61000-6-4 +A1: 2007/2011
The device is designed for use in an industrial environment.
● EC directive 94/9/EC "Equipment and protective systems intended for use in potentially
explosive atmospheres" (ATEX Explosion Protection Directive)
– EN 60079-0:2006: Potentially explosive atmosphere - general requirements
– EN 60079-15: 2005: Type of protection 'n'
● EC directive 2006/95/EEC "Electrical Equipment Designed for Use within Certain Voltage
Limits" (Low Voltage Equipment Directive)
– EN 61131–2 / IEC 61131–2 (programmable logic controllers, part 2: equipment
requirements and verifications)
The EC Declaration of Conformity is available for the responsible authorities according to the
above-mentioned EC Directive at the following address:
To Next Page
Loading...
