19/70
Siemens PXM20 / PXM20-E operator unit CM110754en_02
Building Technologies Settings 17 Dec 2009
3.2 PXM20 operator unit
Note
The procedure for defining or modifying settings in the PXM20 is
always the same. It is therefore described here once only. The same
procedure applies to Sections 3.2.1… 3.2.17.
1. Open Alarming & functions > Settings for the current site.
2. Select the required entry; the value will start flashing.
3. Configure the value as required.
4. Always save the new settings and restart the PXM20 operator
unit.
To Next Page
Loading...
