22/70
Siemens PXM20 / PXM20-E operator unit CM110754en_02
Building Technologies Settings 17 Dec 2009
Figure 3-9 One device visible
5. Save the new settings and restart the PXM20 operator unit.
After a restart, only the devices set to Visible can be seen.
When you are logged in, only alarms from the visible devices are
displayed.
With View restriction = On, the red Alarm LED lights up in the
event of an alarm even if you are not logged in.
Set the view restriction to Off under Settings. When you save this
setting and restart the operator unit, all devices are visible again.
The user-specific view-restriction settings remain in memory. This
means that you only need to enable or disable the view restriction.
Always save new and modified settings and restart the PXM20
operator unit to make the new settings take effect.
3.2.4 Date and time format
Select either the American or the European date and time format.
3.2.5 Contrast
The display contrast can be set here:
Disabling the
view restriction
To Next Page
Loading...
