21/70
Siemens PXM20 / PXM20-E operator unit CM110754en_02
Building Technologies Settings 17 Dec 2009
function can be enabled here. The same dialog box is also used to
enter the IP address of the device with BBMD functionality.
Figure 3-6 Foreign device enabled
3.2.3 View restriction
PXM20/PXM20-E units are delivered with the default setting View
restriction = Off (Figure 3-7). This means that all sites and devices
are visible. Use this menu to configure the site and devices that y
ou
need to see.
1. Log into the site for which you want to configure a restricted view.
If the setting is View restriction = On, you will be able to see
this site only
2. Set View restriction = On (Figure 3-8)
Figure 3-7 Default setting a the new
operator unit: View restriction = Off
Figure 3-8 View restriction = On
3. The devices associated for that site are displayed. They are all
set to Hidden.
4. Select the devices you want to be able see for your work, and set
them to Visible (Figure 3-9).
Note
It is recommended that the Prima
ry Device also be set to Visible.
To Next Page
Loading...
