26/70
Siemens PXM20 / PXM20-E operator unit CM110754en_02
Building Technologies Login and log-out 17 Dec 2009
4 Login and log-out
As soon as you connect the PXM20 operator unit to an automation
station or to a connection point in the L
ONWORKS network, the "Start"
window will appear in the display panel.
Figure 4-1 "Start" window
Press the direct access key adjacent to START.
4.1 Connecting to the network
A connection is established with the network. The PXM20 starts by
looking for an automation station defined as the primary server.
The login procedure is in two steps:
1. Select a site
If no sites are listed, this means that no automation station in the
network has been defined as the primary server.
To Next Page
Loading...
