61/70
Siemens PXM20 / PXM20-E operator unit CM110754en_02
Building Technologies Service support 17 Dec 2009
11.2 The Wink command
In certain cases where third-party integration is involved, the PXM20
may need to be specifically identified for commissioning purposes.
Note
Although it exists in the PXM20, this command is not needed within
the DESIGO system.
The identification process is carried out with the Wink command.
Figure 11-5 The “Wink” command
To send the Wink command, select Send service pin message.
This immediately triggers the Wink signal.
Figure 11-6
To Next Page
Loading...
