Siemens DESIGO PXM20 - Alarm Acknowledgement

35/70
Siemens PXM20 / PXM20-E operator unit CM110754en_02
Building Technologies Alarms 17 Dec 2009
Symbols in the alarm pop-up
Unacknowledged alarm
Alarm state acknowledged
Normal state, existing alarm unacknowledged
Normal state, unreset
(only used for Extended alarms. In such cases, reset the alarm.)
System event
Press ESC to delete a pop-up window without affecting the alarm or
event.
An audible signal can also be canceled by deleting the associated
pop-up window with ESC.
7.2 Alarm acknowledgement
All alarms still requiring acknowledgement are listed in the Alarm
viewer.
7.2.1 Displaying the alarm viewer
You can go to the Alarm viewer either from the
Alarming & functions window, or display it directly from the alarm
pop-up.
Figure 7-2 Alarm viewer
Deleting a pop-up
Canceling
audible signal