Siemens HiPath 4000 - Page 118

Appendix
108
The following appears
immediately after the
Talk key is pressed:
Connect.
No dial tone available;
no calls can be made.
Communication sys-
tem is being used by
other users.
Repeat call later.
The following,
for example, appears:
Base 1
Outgoing and incom-
ing calls and activation/
deactivation are not
possible.
Handset is blocked. Remove the battery pack
from the handset and
then re-insert it. Pro-
ceed as when loading
batteries for first time
(Æ Page 19).
The following appears:
Time exceeded
Maximum input time
was exceeded.
Avoid long pauses
between keystrokes.
The on-hook key was
not pressed.
Press the On-hook key.
The following appears:
Re-enter code:
The communication
system is overloaded.
Wait and try again later.
The following appears:
Not available
Function is currently
not available.
Wait and try again later.
No connection under
the phone number
dialled available.
Enter the phone number
correctly or call the
attendant console.
The following appears:
Feature not avail.
or:
Incorrect entry.
or:
Key not pro-
grammed.
Speed dial number not
available, appointment
entered incorrectly,
entry blocked or not
allowed, prerequisite
not fulfilled
(for example, no second
partner for toggling),
number dialled was
incomplete.
Correct your input,
select a permitted
option, enter the phone
number in full.
The following appears:
no access
Blocked function was
called.
Apply to the relevant ser-
vice personnel for the
COS for the blocked
function.
The following appears:
Denied
Incorrect PIN was
entered.
Enter the correct PIN.
Error Possible cause Remedy