Siemens Hipath 5000 - Page 148

Technical Reference
A31003-01010-M11-1-7619, 29/01/2007
4-14 HiPath 2000, HiPath 3000/5000, HiPath 4000 - OpenStage 60/80, Administrator Manual
referenz.fm
Menus
||||---Terminal name -> Section 3.4.1.1
||||---Display identity -> Section 3.4.1.2
|||
|
--- Enable ID -> Section 3.4.1.2
|||---SIP Interface
||||---Outbound proxy -> Section 3.4.3.4
||||---Default OBP domain -> Section 3.4.3.4
||||---SIP transport -> Section 3.4.3.5
|||
|
--- Response timer (ms) -> Section 3.4.3.3
|||---Registration
||||---SIP Addresses
|||||---SIP server -> Section 3.4.4.1
|||||---SIP registrar -> Section 3.4.4.1
|||||---SIP gateway -> Section 3.4.4.1
||||---SIP Session
|||||---Session timer -> Section 3.4.6
|||||---Session duration (s) -> Section 3.4.6
|||||---Registration timer -> Section 3.4.5
|||||---Server type -> Section 3.4.5
|||||---Realm -> Section 3.4.5
|||||---User ID -> Section 3.4.5
||||
|
--- Password -> Section 3.4.5
|||
|
--- SIP Survivability
||| |---Backup registration flag -> Section 3.4.7
||| |---Backup proxy address -> Section 3.4.7
||| |---Backup registration timer (s) -> Section 3.4.7
||| |---Backup transport -> Section 3.4.7
|||
|
--- OBP flag -> Section 3.4.7
|||---SNMP
||||---Trap sending enabled -> Section 3.3.8
||||---Trap destination -> Section 3.3.8
||||---Trap destination port -> Section 3.3.8
||||---Trap community -> Section 3.3.8
||||---Diag sending enabled -> Section 3.3.8
||||---Diag destination -> Section 3.3.8
||||---Diag destination port -> Section 3.3.8
||||---Diag community -> Section 3.3.8
||||---QoS traps to QCU -> Section 3.3.8
||||---QCU address -> Section 3.3.8
||||---QCU port -> Section 3.3.8
||||---QCU community -> Section 3.3.8
|||
|
--- QoS to generic destination -> Section 3.3.8
||
|
--- Features
|| |---Configuration
|| ||---General
|| |||---Emergency number -> Section 3.4.2
|| |||---Voicemail number -> Section 3.4.2
|| |||---Allow refuse -> Section 3.5.1
|| |||---Initial digit timer -> Section 3.5.3
|| |||---Allow uaCSTA -> Section 3.5.7
|| |||---Transfer on Hangup -> Section 3.5.3.2
|| ||
|
--- Not used timeout -> Section 3.5.8
Menu Further information ...