EasyManua.ls Logo

Siemens Hipath 5000 - 3 Administration; Access Via Local Phone

Siemens Hipath 5000
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
administration.fm
A31003-01010-M11-1-7619, 29/01/2007
HiPath 8000 - OpenStage 60/80, Administrator Manual
3-1
Administration
Access via Local Phone
3 Administration
This chapter describes the configuration of every parameter available on the OpenStage 60/80
phones. For access via the local phone menu, see the following; for access using the web in-
terface, please refer to Section 2.5.1, “Access the Web Interface (WBM)”.
3.1 Access via Local Phone
1. Enter Numbers and Letters
The number keys on the keypad are assigned to multiple functions, i. e. number and letters.
On pressing a number key, a choice of different values appears underneath the input field.
For example, the „2“ key invokes „a b c 2“. If you want to enter the digit „2“, press the key
and hold it down until the choice disappears, which should take about 1 second. For enter-
ing any other value, simply step through the differents values by pressing the key repeat-
edly, and then wait about a second. If the value to be entered is followed by another value
which is derived from another key, you can press the new number key immediately without
waiting a second.
2. Access the Administration Menu
Press the
v key once or twice to activate the administration menu (the v key toggles be-
tween the user’s configuration menu and the administration menu). When the Admin menu
is active, you will be prompted to enter the administrator password. The default admin
password is „123456“. It is recommended to change the password (see Section 3.12,
“Password”) after your first login.
The following figure shows all the navigation keys available:
3. Navigate within the Administration Menu
Use the TouchGuide to navigate and execute administrative actions in the administration
menu.
For using the TouchGuide, see the following figure:
>
The data entered in input fields is parsed and controlled by the phone. Thus, data is
accepted only if it complies to the value range.
t Telephony (Home)
u Phone Book
w Call Log
x Messages
v Menu
y Help
Slide your finger over the TouchSlider:
- set up volume

Table of Contents

Other manuals for Siemens Hipath 5000

Related product manuals