hwc_vnsconfiguration.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
147
Virtual Network configuration
Authentication for a VNS
The selected server is no longer available in the RADIUS drop-down list.
The server name now appears in the list of configured servers, next to the Up and Down
buttons, where it can be prioritized for RADIUS redundancy. The server can also be
assigned again for MAC-based authentication or accounting purposes.
A red asterisk appears next to Auth, indicating that a server has been assigned.
6. In the Port box, type the port used to access the RADIUS server. The default is 1812.
7. In the # of Retries box, type the number of times the HiPath Wireless Controller will
attempt to access the RADIUS server.
8. In the Timeout box, type the maximum time that a HiPath Wireless Controller will wait for
a response from the RADIUS server before attempting again.
9. In the NAS Identifier box, type the Network Access Server (NAS) identifier. The NAS
identifier is a RADIUS attribute that identifies the server responsible for passing information
to designated RADIUS servers and then acting on the response returned. This is an
optional step.
10. In the Include VSA Attributes section, click the appropriate checkboxes to include the
Vendor Specific Attributes in the message to the RADIUS server:
To Next Page
Loading...
Need help?
General
