hwc_startup.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
59
Configuring the HiPath Wireless Controller
Performing the first-time setup of the HiPath Wireless Controller
This report displays all defined routes, whether static or OSPF, and their current status.
3. To update the display, click Refresh.
4.2.6 Setting up OSPF Routing
To enable OSPF (OSPF RFC2328) routing, you must:
● Define one data port as a router port in the IP Addresses screen
● Enable OSPF globally on the HiPath Wireless Controller
● Define the global OSPF parameters
● Enable (or disable) OSPF on the port that you defined as a router port
Ensure that the OSPF parameters defined here for the HiPath Wireless Controller are
consistent with the adjacent routers in the OSPF area. This consistency includes the following:
● If the peer router has different timer settings, the protocol timer settings in the HiPath
Wireless Controller must be changed to match, in order to achieve OSPF adjacency.
To Next Page
Loading...
