Siemens HiPath AP2620 - Completing the System Configuration; Ongoing Operations of the Controller, Access Points and Convergence Software

hwc_startup.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
67
Configuring the HiPath Wireless Controller
Completing the system configuration
4.3 Completing the system configuration
Once you have performed the initial configuration of the HiPath Wireless Controller, you are
now ready to do the following:
● Configuring the VNS – For more information, see Section , “Virtual Network Services”, on
page 107.
● Registering and assigning APs to the VNS – For more information, see Section ,
“Configuring the wireless AP”, on page 69.
4.4 Ongoing Operations of the Controller, Access Points and
Convergence Software
Once you have configured the VNS and registered and assigned APs to the VNS, the
Controller, Access Points and Convergence Software system configuration is complete.
Ongoing operations of the Controller, Access Points and Convergence Software system can
include the following:
● HiPath Wireless Controller System Maintenance
● Wireless AP Maintenance
● Client Disassociate
● Logs and Traces
● Reports and Displays
For more information, see Section , “Performing system maintenance”, on page 241.