Siemens HiPath AP2620 - Working with third-party APs; Step 1 - Define a data port as a third party AP port

hwc_3rdpartyaps.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
213
Working with third-party APs
9 Working with third-party APs
You can set up the HiPath Wireless Controller to handle wireless device traffic from third-party
access points, providing the same policy and network access control. This process requires the
following steps:
● Step 1 – Define a data port as a third party AP port
● Step 2 – Define a VNS for the third-party AP port
● Step 3 – Define authentication by captive portal for the third-party AP VNS
● Step 4 – Define filtering rules for the third-party APs
To set up third-party APs:
Step 1 – Define a data port as a third party AP port
1. From the main menu, click Wireless Controller Configuration. The Wireless Controller
Configuration screen appears.
2. From the left pane, click IP Address. The Management Port Settings and Interfaces
screen appears.