Configuring the wireless AP
A31003-W1040-U101-1-7619, July 2006 DRAFT
82 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_apstartup.fm
Modifying wireless AP settings
5.5.1 Modifying a Wireless AP’s status
If during the discovery process, the HiPath Wireless Controller security mode was Allow only
approved Wireless APs to connect, then the status of the wireless AP is Pending. You must
modify the security mode to Allow all Wireless APs to connect. For more information, see
Section 5.3.1, “Security mode”, on page 77.
To modify a wireless AP's registration status:
1. From the main menu, click Wireless AP Configuration. The HiPath Wireless AP screen
appears.
2. In the left pane, click Access Approval. The Access Approval screen appears, displaying
the registered wireless APs and their status.
To Next Page
Loading...
