Virtual Network configuration
A31003-W1040-U101-1-7619, July 2006 DRAFT
184 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Configuring Quality of Service (QoS)
To configure QoS Policy on a VNS:
1. From the main menu, click Virtual Network Configuration. The Virtual Network
Configuration screen appears.
2. In the left pane Virtual Networks list, click the VNS you want to configure for QoS.
3. Click the QoS Policy tab.
4. From the Wireless QoS list, select the following:
● Legacy – Select if your VNS will support legacy devices that use SpectraLink Voice
Protocol (SVP) for prioritizing voice traffic. If selected, the Turbo Voice option is
displayed.
● WMM – Select to enable WMM. WMM is part of the 802.11e standard for QoS <<<
attention reviewer: need descriptions of what this option does.>>. If selected, the
Turbo Voice and the Advanced Wireless QoS options are displayed.
● 802.11e – <<< attention reviewer: need descriptions of what this option does.>>
Select to enable the 802.11e standard. If selected, the Turbo Voice and the Advanced
Wireless QoS options are displayed:
To Next Page
Loading...
