Working with the Mitigator
A31003-W1040-U101-1-7619, July 2006 DRAFT
220 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_mitigator.fm
Running Mitigator scans
3. In the Scan Group Name box, type a unique name for this scan group.
4. In the Wirelss APs list, select the checkbox corresponding to the Wireless APs you want
included in the new scan group, which will perform the scan function.
5. In the Radio drop-down list, select one of the following:
● Both – The 2.4 GHz and 5.0 GHz radios both perform the scan function.
● 2.4 GHz – Only the 2.4 GHz radio performs the scan function.
● 5.0 GHz – Only the 5.0 GHz radio performs the scan function.
6. In the Channel List drop-down list, select one of the following:
● All – Scanning is performed on all channels.
● Current – Scanning is performed on only the current channel.
>
A Wireless AP can participate in only one Scan Group at a time. It is
recommended that the Scan Groups represent geographical groupings of
Wireless APs.
To Next Page
Loading...
