Working with reports and displays
A31003-W1040-U101-1-7619, July 2006 DRAFT
238 HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_reports.fm
Viewing the displays
Client Location in Mobility Zone
You can do the following:
● Sort this display by home or foreign controller
● Search for a client by MAC address, user name, or IP address, and typing the search
criteria in the box
● Define the refresh rates for this display
● Export this information as an xml file
Mobility Tunnel Matrix
● Provides connectivity matrix of mobility state
● Provides a view of:
● Tunnel state
● If a tunnel between controllers is reported down, it is highlighed in red
● If only a control tunnel is present, it is highlighted in yellow
● If data and control tunnels are fully established, it is highlighed in green
● Tunnel Uptime
● Number of clients roamed (Mobility loading)
● Local controller loading
● Mobility membership list
A HiPath Wireless Controller is only removed from the mobility matrix if it is explicitly removed
by the administrator from the Mobility permission list. If a particular link between controllers, or
the controller is down, the corresponding matrix connections are identified in red colour to
identify the link.
The Active Clients by VNS report for the controller on which the user is home (home controller)
will display the known user characteristics (IP, statistics, etc.). On the foreign controller, the
Clients by VNS report does not show users that have roamed from other controllers, since the
users remain associated with the home controller's VNS.
The Active Clients by AP report on each controller will show both the loading of local and foreign
users (users roamed from other controllers) that are taking resources on the AP.
>
The statistics from the mobility manager are updated every thirty seconds,
regardless of the refresh period for the displays.
To Next Page
Loading...
