hwc_startup.fm
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
49
Configuring the HiPath Wireless Controller
Performing the first-time setup of the HiPath Wireless Controller
6. Click Login. The HiPath Wireless Assistant main menu screen appears.
7. From the main menu, click Wireless Controller Configuration. The HiPath Wireless
Controller Configuration screen appears.
8. In the left pane, click IP Addresses. The factory default settings for the HiPath Wireless
Controller are displayed.
>
In the footer of the HiPath Wireless Assistant, the following is displayed:
● [host name | product name | up time]
For example, [HWC | C1000 | 0 days, 17:11]. If there is no key (unlicensed), the
product name will not be displayed.
● User is the user id you used to login in. For example, admin.
● Port Status is the connectivity state of the port. M is for the Management
interface, which is on eth0 and the numbered lights reflect the esa ports on the
system. Green indicates the interface is up and running. Red indicates the
interface is down.
● For the HiPath Wireless Controller models C10 and C100, the footer of the
HiPath Wireless Assistant does not include the link status of the physical
interfaces.
To Next Page
Loading...
