Siemens KG39EAI43 - Sticking brand logo

8.6 Sticking brand logo
Required tools:
Cleaner Buraton® rapid, 1l, for surfaces alco-
holic disinfection
[00080524]
Cleaning cloth antistatic [00341878]
Polishing paste Glasurit Fine polishing paste
562-1602, 375ml
[00311399]
Cotton pads 100% cotton, especially strong, lint-
free and super soft
Hand roller Hard rubber or rubber coated steel
roller
Prerequisite:
Surface to be glued is dry, free of dust, grease and release agents.
There is no moisture precipitation (e.g. from moving cold appliance to warm room).
Optimal processing temperature is from 21 °C to 38 °C, minimum. 18 °C.
1.
If door surface for brand logo stick is inox / plastic:
1. Clean surface with cleaner and wet wipe (1).
2. Let surface dry for approx. 10 s (2).
2.
If door surface for brand logo stick is inox look:
1. Using cotton swab apply small drop of polishing paste on the door surface (1).
2. Wipe back and forth twice over the surface to be glued (2).
3. Polish surface with soft, dry cloth (3).
3. Peel off logo sticker covering foil at one corner.
4.
Do remove covering foil vertically, otherwise single letters can also
be replaced!
Remove covering foil.
5.
Do not touch the adhesive surface.
Touching this surface reduces adhesion.
1. Stick logo on the dedicated position of door (1).
2. Remove protective foil (2).
Logo is installed.
Repair
2020-08-03_58300000002379_ara_en_p Copyright by BSH Hausgeräte GmbH Page69of73