7ML19981FB05 MultiRanger 100/200 – INSTRUCTION MANUAL Page 5
mmmmm
Specifications
Fixed
• 0.17 % per °C deviation from programmed value
Outputs
Transducer drive
•315 V peak
mA Analog
MultiRanger 100/200:
Single or Dual point versions include two mA outputs
• 0-20 mA
• 4-20 mA
• 750 ohm maximum
• Resolution of 0.1%
•Isolated
Relays
1
•One:
•1 control
•Three:
•2 control
• 1 alarm control
•Six:
•4 control
• 2 alarm control
• All relays rated 5A at 250 V AC, non-inductive
Control Relays
• 1, 2 or 4 Form A, NO relays (numbers 1, 2, 4, 5)
Alarm Relay
• 0, 1 or 2 Form C, NO, or NC relay (numbers 3, 6)
Communication
• RS-232 running Modbus RTU and ASCII via RJ-11 connector
• RS-485 running Modbus RTU and ASCII via terminal blocks
Optional
• SmartLinx
®
compatible
1.
All relays are certified only for use with equipment that fails in a state at or
under the rated maximums of the relays.
To Next Page
Loading...
