Installation February 5, 2004 3-7
DirectRay Interface Card Installation
The DirectRay Interface card is PCI-bus compatible, and uses a standard PCI card
install procedure. For installation instructions, refer to the hardware installation
instructions that accompany the Acquisition Workstation.
Figure 3-5 shows the Interface card fiber optic connectors used for the cable that
connects the PXCM to the Interface card.
Figure 3-5.
DirectRay Interface Card Fiber Optic Connectors (for fiber optic cable to
PXCM)
GS20_413.cdr
Connectors
for fiber optic cables
to DirectRay PXCM
(shown with cap
on left connector)
To Next Page
Loading...
