PXCM Web Tool February 5, 2004 5-9
NOTE: To clear your file selection, click the Reset Form button.
4. When you are ready to start the software file transfer, click the Upgrade
button.
The file transfer status is displayed on the page.
5. After the transfer is complete, reboot the Detector to have it start up using the
software you just transferred. For information about rebooting the Detector,
refer to “Powering the Detector On and Off” on page 5-9.
Powering the Detector On and Off
To power the Detector on or off, or reboot it, click the Array Power Control
link on the Array Control Panel page, or the Power link on any of the other Array
pages. The Array Power Control page displays. Click the appropriate button for the
operation that you want to perform.
NOTE: For security purposes, you may be prompted to enter a login name and password before
executing this function. For more information, refer to “Function Security Levels and Login Prompts”
on page 5-2.
To Next Page
Loading...
