Issue 08/03
MICROMASTER 440
6SE6400-5GA00-0BP0
Quick Start Guide 35
3.1.2 Frame Size D to Frame Size F
1 Remove SDP or
BOP by pressing
button.
2 Remove retaining
screw over options
well
5 Use flat blade
screwdriver to
release I/O board
50/60 Hz DIP
switch right
hand switch.
Down = 50Hz,
Up = 60Hz
6 Move DIP switch 2(2)
according to nominal
motor frequency
4 Lift out adapter
board revealing I/O
board
3 Release adapter board
by pressing blue lever
towards top of drive
Once released you
can grip the board
here and remove
Figure 3-2 Removing the I/O board on Frame Size D to Frame Size F MM440
NOTE
Example shown is Frame Size D; Frame Size E & Frame Size F are similar.
3.1.3 Frame Size FX to Frame Size GX
For Frame Size FX & Frame Size GX, locate the I/O board and follow the same procedure as for
Frame Size A.
www . ElectricalPartManuals . com
To Next Page
Loading...
