Issue 08/03
MICROMASTER 440
6SE6400-5GA00-0BP0
Quick Start Guide 9
Table of Contents
1 Mechanical Installation .......................................................................................... 11
1.1 Drilling Patterns and Dimensions....................................................................... 11
1.2 Environment, Heat Loss and Air Flow ............................................................... 14
2 Wiring Guidelines / Electrical Installation ............................................................ 17
2.1 Power Terminal Layouts.................................................................................... 17
2.2 Adaptation of Fan Voltage (Only Frame Size FX and GX) ................................ 20
2.3 Motor and Power Connections .......................................................................... 21
2.4 Recommended Power Supplies for 3ph Connection ......................................... 22
2.5 Removal of Y Capacitor..................................................................................... 23
2.6 Wiring Diagrams for Motors............................................................................... 24
2.7 When to Use Line Reactors (Input Chokes) ...................................................... 25
2.8 When to Use Load Reactors (Output Chokes) .................................................. 25
2.9 Fuses, Circuit Breakers, Line Reactors, Output Reactors ................................. 26
2.10 Power Cable Dimensions .................................................................................. 29
3 50Hz / 60Hz Switch ................................................................................................. 33
3.1 How to Remove I/O Card to Get At Switches .................................................... 34
4 Control Wiring......................................................................................................... 37
4.1 Control Block Diagram,...................................................................................... 37
4.2 Control Wiring Examples ................................................................................... 38
5 Setting Parameters................................................................................................. 43
5.1 Introduction to Basic Operator Panel (BOP)...................................................... 43
5.2 Factory Reset .................................................................................................... 44
5.3 Commissioning an MM440 ................................................................................ 44
5.4 Reading Motor Name Plates ............................................................................. 45
5.5 Level 3 Quick Commissioning ........................................................................... 46
5.6 Checking Direction of Motor Rotation ................................................................ 52
5.7 Parameter Filter Function .................................................................................. 52
5.8 Setting up Inputs and Outputs, .......................................................................... 53
5.9 Other Commonly Used Features ....................................................................... 60
6 Troubleshooting ..................................................................................................... 62
6.1 Troubleshooting Using the Status Display Panel (SDP) .................................... 62
6.2 Faults and Alarms (Warnings) ........................................................................... 64
6.3 Where to Get Additional Technical Information ................................................. 67
www . ElectricalPartManuals . com
To Next Page
Loading...
