MOBILETT Plus / - E/ - M SPR8-215.898.01 Page 12 of 28 Siemens-Elema AB
Rev. 05 01.02 SPS-UD Solna, Sweden
10 - 12 Mechanical systems
MOBILETT Plus and Plus M only
• Remove the tilt bar (Fig. 14).
• Remove the supporting wheels behind the tilt bar.
• Jack up and block the unit securely 5 cm above the floor. This must be done properly so
that the unit does not tip over.
• Disconnect all cables, ground connection and K68, according to (Fig. 15).
Fig. 14
Fig. 15
Shaft
K68
Locking
Locking ring
ring
To Next Page
Loading...
