4.1.3 Internal DIP switches
The internal DIP switches enable a download session via FTP using a default IP
address.
Note: There are two internal DIP switches, but only DIP switch 2 is presently used.
Internal switch Functions
DIP switch 1 Not presently used.
DIP switch 2 Default mode/network access:
If DIP-switch 2 is ON, an FTP connection occurs by default on the
Ethernet at the default IP address 192.168.9.41.
Internal DIP switches
4.1.4 Internal jumpers
The internal jumpers are used for:
JP3: When closed, it disables the box tamper alarm;
JP6: When closed, it enables the LON termination resistor (100Ù) for a doubly
terminated bus topology.
Fig. 12 Internal DIP switch and jumpers
To Next Page
Loading...
